Recommeded Protective Finish

For gloss canvas prints we recommend the a protective finish called Bulldog Ultra. This is a solvent borne vinyl elastomer clear coat. While the inks themselves are already UV resistant inks, the coating also has some additional UV buffers . Most importantly is the fact when applied to the print, the finish can further protect it from scratching, finger prints, or smudging.

How it is Applied - The finish should be sprayed on or rolled with a dense foam roller on the printed surface as a single coat. Typically the finish will dry within a half hour. This process does require some practice and when applied incorrectly can leave streaks or roller marks. Since it has to be applied in a very well ventilated place, sometimes hi levels of humidity in the air can slow down the drying process. If you plan on painting over your print, the Bulldog Ultra should give the canvas the needed protection.

Note: This finish can be very toxic and should be applied in a well ventilated place. Fumes from the finish can linger on the print for up to 72 hours.

Other Coatings

We have tested several coating solutions meant to help preserve the prints and also to prepare them if you wish to add embellishments such as paint daubs or brush stroke textures. Keep in mind that any sort of coating, if applied too thickly may give a matte canvas a semi-gloss or satin shine. When applying either of these finishes, we recommend that you apply light coats spaced over a period of time so that the finish does not drip on the print. Please read the instructions on the back of the cans of finish for proper spraying technique.

Krylon® Low-Odor Clear Gloss Finish

For Gloss Canvas

Increases the glossy look. Formulated using true latex technology, Krylon Low-Odor Coatings provide the same quality as traditional Krylon coatings.

Please use this at your own risk. In no way does this site guarantee this product or can be responsible for final results.

Tips when applying finish yourself

• Place print on a art easel or hang so that the print is facing you and perpendicular to the floor. Room should be well ventilated and low in humidity.
• Use a very soft clean and dry paint brush to remove any dust or lint that might have collected.
• Add a light coat of the appropriate finish, holding approximately 12” away from the printed surface. Keep coating light enough so that the finish does not run (also see the instructions on the back of the can).
• Allow the finish to dry (drying times vary so see the instructions on the back of the can).
• Repeat the previous tip at least once or twice. More so if you plan on adding embellishments.

Grumbacher Tuffilm® Final Fixative

For Matte Canvas

Does not give a glossy look. Protects printed matter, proofs, drawings, charcoal and pastel drawings, blueprints, and photographs from dirt, dust, and moisture. It will not change the hue of colors or stain paper.

Please use this at your own risk. In no way does this site guarantee this product or can be responsible for final results.